Thingiverse
Geeetech A10, A10M and A10D Cable Management Loop
von Trevor_Avrett
265
Downloads
141
Likes
1
Makes
STL file should be to scale, (unless thingiverse shrinks them for compression). This is a cable management system, spec'd from a Geeetech A10(/M/D), and should fit similar models.
This bracket curves wrap around tower piece's side fillets for better grip, and the cylindrical prongs are designed to be a tight fit inside the holes, (as seen in the second picture).
Forgive my print quality: this was my second print ever on my own printer
This bracket curves wrap around tower piece's side fillets for better grip, and the cylindrical prongs are designed to be a tight fit inside the holes, (as seen in the second picture).
Forgive my print quality: this was my second print ever on my own printer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
