Geeetech A10 Diamond Hot End

This I my first gen diamond hot end conversion for the Geeetech A10. My printer had GT2560 v3 board that has 2 extra slot for stepper drivers.

I printed the part on My Anet A8 as the A10 was in pieces for reverse engineering

In addition to the extra, motors, driver, extruders and Bowden hardware you will need:
2x 50mm fans
3x M3x10mm bolts
9x M3x15mm bolts
5x M3 nuts
2x M3x65mm threaded rod

Please note that the thread for the fan bolts is printed into the parts so nuts should not be needed (very hard to get in place anyway) and overtightening will strip the thread out.

The BL touch offset is 30.26 to the left and 14.3 to the front when setting marlin
I thing the part cooler needs a new design as I'm currently not 100% happy with the bridging results that I am getting.
I have mine printed IN PLA as that I what I have and what I generally use.

There are some other bits that I need to design up along side a new part cooler, like updated motor mounts and bracket to ch