Thingiverse

Geeetech A10 Fan Duct

by Estep

76 Downloads

59 Likes

1 Makes

Geeetech A10 Fan Duct - Work in Progress!

Since the original Geeetech radial part cooling fan has been extremly loud and the original duct hasn't been ideal too, I tried to improve the duct. This makes the printer a lot quieter but not exactly silent with the 24V Sunon EB40202S2-999 fan I used. Print quality has been improved slightly too on overhangs with PLA.

I printed the "Top"-Part with PLA. "Buttom"-Part with PETG. The "Tip" needs to be printed with ASA or ABS, because even PETG might soften because of the heat that comes from the hotend. A silicone sock for the hotend is recommended. You can find a printable mold for a silicone sock on my thingiverse.

Top needs to be printed with supports everywhere. Buttom only on build plate.

Additional Parts needed:
2 screws M2x8mm

a10 air shroud Axial cooling fan duct Estep geeetech Geeetech A10 luefter Lüfter noctua shroud sunon a10 air shroud Axial cooling fan duct Estep geeetech Geeetech A10 luefter Lüfter noctua shroud sunon

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

supports needed

Single piece Supports required Hardware needed

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer