Geeetech A10 Firmware

This is Marlin Firmware ver 2.0.8.1 for the Geeetech A10. This will NOT work for the A10M ot A10T models.

Use at your own risk. No warranties or guarantees expressed or implied.

This works on my machine which is completely stock.
Manual bed leveling is enabled

Board: GT2560 v4.0

SERIAL_XON_XOFF = OFF
BINARY_FILE_TRANSFER = OFF
EEPROM = ON
VOLUMETRIC = ON
AUTOREPORT_POS = OFF
AUTOREPORT_TEMP = ON
PROGRESS = OFF
PRINT_JOB = ON
AUTOLEVEL = OFF
RUNOUT = ON
Z_PROBE = OFF
LEVELING_DATA = ON
BUILD_PERCENT = OFF
SOFTWARE_POWER = OFF
TOGGLE_LIGHTS = OFF
CASE_LIGHT_BRIGHTNESS = OFF
EMERGENCY_PARSER = OFF
PROMPT_SUPPORT = OFF
SDCARD = ON
REPEAT = OFF
SD_WRITE = ON
AUTOREPORT_SD_STATUS = OFF
LONG_FILENAME = ON
THERMAL_PROTECTION = ON
MOTION_MODES = OFF
ARCS = ON
BABYSTEPPING = ON
CHAMBER_TEMPERATURE = OFF
COOLER_TEMPERATURE = OFF
MEATPACK = OFF