Thingiverse
Geeetech A30 LED lighting
von innsomniac
96
Downloads
41
Likes
0
Makes
By popular demand, I'm sharing my Geeetech A30's lighting setup.
The support names are self-explanatory. The 280mm light bar goes between the z wheels, on the x-Axis gantry.
For the top, you can print either the 280mm, the 330mm or the 400mm light bar for both front and back.
All the parts printed fine at 0.2mm layers.
You may need a brim for the support brackets, and the lightbars require some supports (for the slot), and potentially a brim too.
The support names are self-explanatory. The 280mm light bar goes between the z wheels, on the x-Axis gantry.
For the top, you can print either the 280mm, the 330mm or the 400mm light bar for both front and back.
All the parts printed fine at 0.2mm layers.
You may need a brim for the support brackets, and the lightbars require some supports (for the slot), and potentially a brim too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
