GEEETech i3 Acrilyc frame LED strip mounts

LED strip frame mount for
GEEETech i3 proB acrilyc frame or any other fram with an approx. 8mm thickness.

Printed in 0.2mm 3 layers no infill.
Use 5-6mm brim to make sure it stays stuck to the bed during print.
Has left and right side hole variant to make the wireing easier to tidy up.
I connected it to FAN3 on my GT2560 since that one was not in use

#####LEDs I used:
https://rover.ebay.com/rover/1/710-53481-19255-0/1?icep_id=114&ipn=icep&toolid=20004&campid=5338291225&mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fitm%2F5050-LED-Strip-Light-12V-Car-Caravan-White-Blue-Red-Green-Warm-White-10-30-cm%2F262453353235%3FssPageName%3DSTRK%253AMEBIDX%253AIT%26var%3D561256772536%26_trksid%3Dp2057872.m2749.l2649

#####PLUGS You need to connect it up to the board:
https://www.ebay.co.uk/itm/10x-PH-2-0mm-connector-plug-PCB-crimps-male-female-lipo-battery-2-3-4-Pin-Header/331923478833?ssPageName=STRK%3AMEBIDX%3AIT&var=540982114806&_trksid=p2057872.m2749.l2649

#####Just use some double sided