Thingiverse
Geeetech i3 Pro B LCD Relocator
door IWIMake
44
Downloads
23
Likes
0
Makes
Do you have an acrylic Geeetech i3 Pro B?
Do you want to move your LCD control panel to the front of the Y axis ala Prusa i3?
Do you not need a complete enclosure?
Give this a go!
These use the existing M10 threaded rod, washers and nuts at the front of the Y axis and 2x 10mm long self tapping philips head screws which came with the printer.
Use the existing acrylic spacer parts by turning them upside down so that the mounting screw holes appear at the top.
*****WARNING*****
Only use these if the printer is on a level surface large enough for the front edge of the LCD acrylic surround to rest on. These mounts WILL SNAP if the front of that piece is not supported.
Do you want to move your LCD control panel to the front of the Y axis ala Prusa i3?
Do you not need a complete enclosure?
Give this a go!
These use the existing M10 threaded rod, washers and nuts at the front of the Y axis and 2x 10mm long self tapping philips head screws which came with the printer.
Use the existing acrylic spacer parts by turning them upside down so that the mounting screw holes appear at the top.
*****WARNING*****
Only use these if the printer is on a level surface large enough for the front edge of the LCD acrylic surround to rest on. These mounts WILL SNAP if the front of that piece is not supported.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
