Thingiverse
GeeeTech i3 Pro Raspberry Pi 2B Holder
door antonfelich
5
Downloads
3
Likes
0
Makes
Took 12v from the existing power supply for the fan, and then through a buck converter to get 5v for the Raspberry Pi.
The next steps will be set up Octoprint so I can do wireless prints and watch it through a webcam!
I've included the Fusion 360 files in case you want to mess around.
You'll need: -
4 x M2 @ 20mm + Nuts (To hold the board down)
4 x M3 @ 20mm + Nuts (To close the case)
2 x M3 @ 30mm + Wing Nuts (To attach to the printer)
Print, assemble, then it slots into the front of the Y Axis front support next to the belt. You'll need to drill a couple of holes through the perspex and then use the 30mm bolts and wingnuts to tighten.
The next steps will be set up Octoprint so I can do wireless prints and watch it through a webcam!
I've included the Fusion 360 files in case you want to mess around.
You'll need: -
4 x M2 @ 20mm + Nuts (To hold the board down)
4 x M3 @ 20mm + Nuts (To close the case)
2 x M3 @ 30mm + Wing Nuts (To attach to the printer)
Print, assemble, then it slots into the front of the Y Axis front support next to the belt. You'll need to drill a couple of holes through the perspex and then use the 30mm bolts and wingnuts to tighten.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
