GeminiTay Figure

Gem 3D print based on Gem's skin. The arms and head can move.

There are two versions: for sitting print out the two legs for sitting, and for standing print out the two STLs for standing

Gem Recommended Settings:
-Use supports for the head and arms only

-Nondetailed (nonpixeled) side normal to the baseplate

-Glue eyes (and other pieces) if needed

-Sanding may be needed for the best results

-Slower speeds allow for better angles on the pixels though the effect is usually minimal

Painting:
-Use lighter filament than the color desired

-Used acrylics (but I imagine there's a better way)

-A couple of layers are needed and make sure to have a paper towel to wipe off mistakes

Notes: Flowers are made out of quilling paper