Thingiverse
Gen 6 Electronics enclosure
von Logzy
11
Downloads
17
Likes
3
Makes
This is a forced cooling enclosure i created to suit the Gen 6 electronics.
The fan duct is glued onto the main cover as im too lazy to change it to a snap on, plus glued could have several advantages.
The cover snaps onto the base and a 40mm fan is attached to the fan duct.
This creates a wider higher pressure flow of air for cooling in the important places.
It provides good forced cooling keeping the board cool.
The fan duct is glued onto the main cover as im too lazy to change it to a snap on, plus glued could have several advantages.
The cover snaps onto the base and a 40mm fan is attached to the fan duct.
This creates a wider higher pressure flow of air for cooling in the important places.
It provides good forced cooling keeping the board cool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
