General Print Calibration Test Benchy

Tired of running long calibration tests on your printer? Run this quick general-purpose test model instead! Weighing in at ~3 grams and taking ~10 minutes to print, this model is perfect for quickly testing tuning settings and filaments and is designed to be a bit more informative than the boat benchy. This should be used to evaluate what calibration tests you should run on your filament. Here's an over view of the model and what each section is designed to test: From the back view you can view the markers for the overhang test. The marks correspond to the angles below:Evaluating Print Results:Flow Rate Test: The back area of the model should be smooth to the touch. If there are tiny gaps between the lines in the main area, your flow ratio should be increased. If the lines are raised or the surface feels rough/bumpy, your flow ratio should be decreased. You can run the Flow Dynamics and Flow Rate tests on your slicer.Overhang Test: Most printers/filaments should handle 30-45 degree