General Purpose Box for Hobbyists

This is intended to be a general-purpose box not overly customized to any particular use. It may be used as a simple 2-part divided box or a box with trays for small parts. Each side of the box will a combination of one low (17mm) tray and one tall (25mm) tray. I printed this in PETG although other filaments should do fine. If you are going to use the box for anything heavy, I would increase the infill to 30%. I like to rub a tiny bit of paste wax onto the edge of my sliding lids as it improves movement. I use Renaissance Wax since it works well in my other hobbies, but any will do.Boost MeI'm just a geezer doing 3D printing and design to keep my brain active until I start CTD or become DRT. A little positive attention keeps me going. For you non old school emergency personnel, or those who only know modern approved abbreviations:CTD is Circling the Drain and DRT is Dead Right ThereCheers!