Thingiverse
Generative Design Cinewhoop (3inch)
di kowloonfpv
5
Download
4
Likes
0
Makes
Fully "printable" TPU Generative Design Cinewhoop
Why TPU? There will no more jello from your footage because everything is soft:)
The motors was mounted 20 degrees outward to provide stability with smaller drone size
The duct might too tight for some props, you may need to heat it up reshape it and make it more clearance . Remember minimum clearance to archive more thrust
Drone spec:
Any 30A 4in1 ESC 20*20 / 30*30
Motor : 1408 3600kv
props : 3inch
battery :4s /6s
Make sure you chose a correct motor on it ,a "HOT MOTOR" could melt the TPU frame
Video1 : https://fb.watch/4QH7mFj8SS/
Video2 : https://fb.watch/4QHfo5y81v/
The improved design available HERE
https://www.thingiverse.com/thing:4830904
Why TPU? There will no more jello from your footage because everything is soft:)
The motors was mounted 20 degrees outward to provide stability with smaller drone size
The duct might too tight for some props, you may need to heat it up reshape it and make it more clearance . Remember minimum clearance to archive more thrust
Drone spec:
Any 30A 4in1 ESC 20*20 / 30*30
Motor : 1408 3600kv
props : 3inch
battery :4s /6s
Make sure you chose a correct motor on it ,a "HOT MOTOR" could melt the TPU frame
Video1 : https://fb.watch/4QH7mFj8SS/
Video2 : https://fb.watch/4QHfo5y81v/
The improved design available HERE
https://www.thingiverse.com/thing:4830904
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
