Generic BT-80 Ogive Nosecone

This a generic Ogive nosecone for a BT-80 model rocket tube. The point at the top is blunted with a 4mm hemisphere. Due the the height. It is too tall to print in one piece on most printers, so I broke it up into 3 pieces that screw together. One piece is the shoulder and the other two are the nosecone. I also noticed there was enough room on the inside to fit an electronics bay so I set that up. The sled is a blank so you can drill holes for zip ties or put screws in it or remix it to suit you needs. There is enough clearance in the center for a 9v battery if you want.

The bay slides into the bottom section of the cone from below, and when the shoulder is screwed in it holds it firmly in place. If you plan to use the bay, don’t glue the shoulder on. It is up to you if you want to glue the top nosecone section to the bottom section or not. If you do, apply the glue sparingly to the threads in the top section, so as it screws tother the glue is squeezed up to the inside of the con