Generic Nano Holder

I printed the Nano Holder by TheCaveFire, tried to install my nano and realized the generic models have diodes in the way on the bottom. After a little fidgeting, i discovered a few things i would like to change about it.

I cut out a groove on the usb end on the bottom side of the PCB to accommodate the diodes under the generic nano.

I widened the post/tab that retains the LED end (the side with 2 screw holes), i also trimmed it at about a 45° so that it wouldn't need support, but still gives a little thumb grab. The tab snapped off right after i touched it on the original, but i'm a 3Dprinting noob, so maybe i printed it bad, but this is literally my first remix and my first time opening blender in literally a decade, so i hope y'all like it. I also extended the little retaining ridge, mine printed pretty snug.

I pretty much doubled the side walls to give a little side-to-side retention strength, i also clipped the top of the boxed corners to require less flex to install the