Thingiverse
Generic squash ball feet
von Gaviols
14
Downloads
6
Likes
0
Makes
https://www.printables.com/it/model/191530-generic-squash-ball-feet
I quickly modified a couple of popular models of squash ball feet because i found out that if you move the printer without lifting it enough, the grip it makes onto the surface might break them off, especially if you glue them without screwing on the chassis (like i did). So i increased the surface they make contact through, so that it reduces the lever in the case it grabs too hard when you move the printer. I advise both a little bit of glue and a screw.
I quickly modified a couple of popular models of squash ball feet because i found out that if you move the printer without lifting it enough, the grip it makes onto the surface might break them off, especially if you glue them without screwing on the chassis (like i did). So i increased the surface they make contact through, so that it reduces the lever in the case it grabs too hard when you move the printer. I advise both a little bit of glue and a screw.
Gaviols veröffentlicht auch auf
17 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
