Gengar - Bookmark / Portrait

Gengar in a dynamic and bold illustration. GengarPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. The bookmark is on plate 1 and plate 2 has the portrait - same swaps.Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Purple Transmission Distance: 3.6 PLA BambuLab Basic Magenta Transmission Distance: 3 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filaments Swap Instructions: Start with Black At layer (0.96mm) swap to Purple At layer (