Gengar Ornament Planter

Hey guys! All the credit goes to @Psdwizzard (https://www.thingiverse.com/thing:5028132).

All I did was make a hole on Gengar to add your favorite succulents! The hole is 60mm in diameter, so no need to scale (I made a little drainage hole as well, everything is considered!). It prints in under 100g of filament with tree supports.

This file is HUGE. Please, allow CURA a few minutes to load the STL (Don't get exhausted if it takes 3 minutes to open the file and another 3min to slice)

Here are my print settings...

Layer height: 0.2mm
Walls: 3
Infill: 12% (Gyroid)
Speed: 60mm/s
Supports Overhang: 80.0 (Tree, Zig Zag, everywhere). I'm sure you can print with fewer supports. I just didn't want a brainer thinking about it. Total supports are about 11g
Build Adhesion: Skirt

Total time: Around 17h

I hope you guys enjoy it!!!! Post your makes with their plants!!!