Thingiverse
Genie Waterpipe
por string120
28
Descargas
25
Likes
0
Makes
Height - 140 mm
Pipe diameter - 13 mm
Choke Diameter - 3 mm
So I've printed this and tested for performance. I found that the neck was too short, which results in water to spit up during the pull through. The choke I found to be to small, not allowing to pull enough air through. I am making modifications and will post version 2 some time within the next few days when I have time. If anyone has tried this, please post a review in the comments, as well as any ideas to improve. also I had to use a sleeve and aluminum bowl and stem, which fits nice, (13.5 mm) but too small for a glass bowl and stem (14mm). in the next model I will change to 14mm to accommodate a glass bowl.
Pipe diameter - 13 mm
Choke Diameter - 3 mm
So I've printed this and tested for performance. I found that the neck was too short, which results in water to spit up during the pull through. The choke I found to be to small, not allowing to pull enough air through. I am making modifications and will post version 2 some time within the next few days when I have time. If anyone has tried this, please post a review in the comments, as well as any ideas to improve. also I had to use a sleeve and aluminum bowl and stem, which fits nice, (13.5 mm) but too small for a glass bowl and stem (14mm). in the next model I will change to 14mm to accommodate a glass bowl.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!