Thingiverse
Genmitsu 3018 Offline command stand
31
Download
20
Likes
0
Makes
Hi everyone.
I designed this stand for the offline command of my Sainsmart Genmitsu 3018 PRO-Ver as I hated have this thing loose on my desk.
While I was as it, I included 2 small boxes in the back for the Z-prob, tools and bits.
On my 3018 actually extended to 3040, it can be places in front, on the right side with one of the spare nuts and bolts from the kit.
On an original 3018 PRO-Ver I assume it could be modified to be attached to one of the bolts holding the right plexiglass panel (I might post that version later-on).
As usual comments and suggestions welcome. I will do my best to upgrade this based on your inputs.
Best.
Le Gluon
I designed this stand for the offline command of my Sainsmart Genmitsu 3018 PRO-Ver as I hated have this thing loose on my desk.
While I was as it, I included 2 small boxes in the back for the Z-prob, tools and bits.
On my 3018 actually extended to 3040, it can be places in front, on the right side with one of the spare nuts and bolts from the kit.
On an original 3018 PRO-Ver I assume it could be modified to be attached to one of the bolts holding the right plexiglass panel (I might post that version later-on).
As usual comments and suggestions welcome. I will do my best to upgrade this based on your inputs.
Best.
Le Gluon
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
