Thingiverse
Geo Metro - Bumper Pushpin
by Eighty_Deuce
0
Downloads
2
Likes
0
Makes
This is a replacement pushpin for mounting the front and rear bumpers on a Geo Metro.
Verified to work on a 1994 Geo Metro and will likely work on other model years.
There are 2 files:
*1 file labeled "Tab" (which is the actual pin).
*1 file labeled Body.
Each part printed separately (in multiples if you like)
I used PLA+ but you can use whatever material that you like.
*100% infill
No supports necessary.
These work and snug up very well in the bumper holes and are strong even with PLA+.
They are so snug when closed that you won't be able to re-use these when using PLA+.
The head of the Tab (Pin) will break off before the pin comes back out.
The body won't break however, so if you need to remove the pushpin, you'll need chisel off the flange of the body and punch the body through the hole and then use a newly printed pushpin.
Verified to work on a 1994 Geo Metro and will likely work on other model years.
There are 2 files:
*1 file labeled "Tab" (which is the actual pin).
*1 file labeled Body.
Each part printed separately (in multiples if you like)
I used PLA+ but you can use whatever material that you like.
*100% infill
No supports necessary.
These work and snug up very well in the bumper holes and are strong even with PLA+.
They are so snug when closed that you won't be able to re-use these when using PLA+.
The head of the Tab (Pin) will break off before the pin comes back out.
The body won't break however, so if you need to remove the pushpin, you'll need chisel off the flange of the body and punch the body through the hole and then use a newly printed pushpin.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!