Thingiverse
geodesic dome
von dav88
4
Downloads
7
Likes
0
Makes
a complete geodesic dome.
print as in picture so no supports or raft.
but i used a brim with 1 skirt layer and 5 skirl outlines. to help keep it stable. it dont think i even needed a skirt/brim. it just looked so vulnerable.
i used 10% infill but i think it dont need any or u might hav to use more top and bottom solid layers and more outline perimeter shells.
i made this small and it is in inches. this was a test size.
u may want to convert to mm and size it up.
print as in picture so no supports or raft.
but i used a brim with 1 skirt layer and 5 skirl outlines. to help keep it stable. it dont think i even needed a skirt/brim. it just looked so vulnerable.
i used 10% infill but i think it dont need any or u might hav to use more top and bottom solid layers and more outline perimeter shells.
i made this small and it is in inches. this was a test size.
u may want to convert to mm and size it up.
dav88 veröffentlicht auch auf
537 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
