Thingiverse
geodesic hub v4
von dav88
15
Downloads
19
Likes
0
Makes
i designed this hub system for use in making a geodesic dome model.
it is a print in place hinge.
you would use a screw to go through the holes in the hinge to secure the hinge to the wood strut.
you would use 3 of theses hinges to make a truncated geodesic dome,
5 to make a pentagon, and 6 to make a hexagon.
print as shown in the supplied stl and gcode, with hinge sections at 90 degree angle.
supports are recommended but may not be needed.
it is a print in place hinge.
you would use a screw to go through the holes in the hinge to secure the hinge to the wood strut.
you would use 3 of theses hinges to make a truncated geodesic dome,
5 to make a pentagon, and 6 to make a hexagon.
print as shown in the supplied stl and gcode, with hinge sections at 90 degree angle.
supports are recommended but may not be needed.
dav88 veröffentlicht auch auf
537 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
