Thingiverse
GEPRC TinyGo drone charger case
by Cadventurer
13
Downloads
7
Likes
0
Makes
Simple housing for the GEPRC TinyGo charger board that comes with the drone.
The case is designed to have a 2mm thick strip of doublesided adhesive band (e.g. the kind used to stick mirrors to bathroom tiles) to be stuck to the bottom in order to hold the charging board in place.
Assembly is straight forward - just slide the charger board into the bottom of the case (after sticking some 2mm tape to the bottom), the USB connector first, then pressing in the USB-C side (this may require a bit of force/bending of the case's wall but with some percussive maintenance it'll go).
I used support material for the LiPo cut-outs (might get away without support though)
The lid should just pop right in.
Only drawback of the lid is that it kind of covers the charging LEDs... but you can still see them enough through the "GEPRC" letters.
The case is designed to have a 2mm thick strip of doublesided adhesive band (e.g. the kind used to stick mirrors to bathroom tiles) to be stuck to the bottom in order to hold the charging board in place.
Assembly is straight forward - just slide the charger board into the bottom of the case (after sticking some 2mm tape to the bottom), the USB connector first, then pressing in the USB-C side (this may require a bit of force/bending of the case's wall but with some percussive maintenance it'll go).
I used support material for the LiPo cut-outs (might get away without support though)
The lid should just pop right in.
Only drawback of the lid is that it kind of covers the charging LEDs... but you can still see them enough through the "GEPRC" letters.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
