Ghost Halloween Decoration

Ghost can sit as is or be hung from a string. The versions labeled “Ghost2” have a tab at the top to tie a string through if you want to hang the ghost

Eyes are printed separately then can be superglued in place

Both the eyes and the ghosts can be printed at 15% infill. Print the ghost with a raft to make sure it stays on the bed while printing

The walls of the ghost are 2mm thick. The original versions take up almost all of a 256x256x256mm print volume. There are smaller versions that are 50% smaller but still have 2mm thick walls to avoid overly thin walls in case you want to scale it down, just remember to scale the eyes down accordingly.

For small ghosts, it helps to scale the eyes to a slightly smaller percentage than the ghost so that they'll fit in the sockets (the small ghost in the picture was scaled down to 25% and its eyes were at 23%)