Ghostbusters ATC/2016 Remote Trigger

This is a wearable replica of the Ghostbusters: Answer The Call (2016) Remote Trigger armband as worn by Holtzmann. In the above photos you can see a close-up screenshot of the prop from the film, as well as one of my fellow South Australia Ghostbusters wearing a prototype replica (I've since made a few adjustments before sharing these files, ). You can also see a photo of one of the stunt (resin/foam?) replicas which was auctioned off a while back, including measurements. This is what I've based mine on.I ended up making the upper-right section into a push button in case I want to add electronics to this in future, but you can glue this in place if you prefer. I also reinterpreted the side rod, I couldn't figure out what was visible from the front opening (it's covered with electrical tape in later scenes) so I decided that this would be the “antenna”. I've included an inner piece which I wrapped in copper wire and installed into the side rod using an M4 bolt. You