Thingiverse
Giant Magnet Pin
door I_need_a_better_name
14
Downloads
11
Likes
0
Makes
I had a 1.375x0.19 inch magnet left over from another project. It was stuck to the storage shelves in my office, languishing. It is too large and powerful to use on its own so I whipped up a "push pin" so it could go on the fridge.
I highly encourage using epoxy, or another strong glue, to retain this in the pin. They're surprisingly strong, and prone to departing the pin at high speed if not glued. Superglue is not strong enough. Trust me.
Magnet: [https://amzn.to/2zkP2zX](https://amzn.to/2zkP2zX)
TIANSE Green PLA Filament: [https://amzn.to/2MUN4bw](https://amzn.to/2MUN4bw)
Loctite E-20HP Hysol Epoxy: [https://amzn.to/2J4AFQ2](https://amzn.to/2J4AFQ2)
Loctite "Epoxy Gun": [https://amzn.to/2KZwS8y](https://amzn.to/2KZwS8y)
Epoxy Nozzles: [https://amzn.to/2KTYVWN](https://amzn.to/2KTYVWN)
I highly encourage using epoxy, or another strong glue, to retain this in the pin. They're surprisingly strong, and prone to departing the pin at high speed if not glued. Superglue is not strong enough. Trust me.
Magnet: [https://amzn.to/2zkP2zX](https://amzn.to/2zkP2zX)
TIANSE Green PLA Filament: [https://amzn.to/2MUN4bw](https://amzn.to/2MUN4bw)
Loctite E-20HP Hysol Epoxy: [https://amzn.to/2J4AFQ2](https://amzn.to/2J4AFQ2)
Loctite "Epoxy Gun": [https://amzn.to/2KZwS8y](https://amzn.to/2KZwS8y)
Epoxy Nozzles: [https://amzn.to/2KTYVWN](https://amzn.to/2KTYVWN)
I_need_a_better_name publiceert ook op
12 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
