Gift Bow Decoration

A simple but elegant bow that can be used to embellish presents when wrapping or used as a decoration in its own right. At 100% scale the bow is approximately 100mm tall by 100mm wide and 16mm thick. The ring at the top is about 10mm internal diameter. I have tried scaling the model up to 150% and the result was pretty good but I wouldn’t recommend scaling down much because the bow ribbon ends are quite thin, I tried it at 50% and the end result was full of holes so don't waste your filament trying to go that low. The model is based on the original design but I have improved the hanging ring so that it is much stronger and easier to remove the print supports. The model needs to be printed with supports or it will definitely fail, I would recommend using the profile that I’ve uploaded because I’ve tried to keep the supports to a minimum and tried to make them as easy as possible to remove. I printed mine using Bambu Lab PLA Basic Red.Boost MeIf you like the model please consider boo