Gift Box Kinetic

Gift box from Tiktok. There are many models of this but all of them require screws and less popular magnet sizes. I edited this model in CAD to support pins made from filament and 6mmx2mm neodymium magnets, which seemed to be the most popular on Amazon. Also included a remix of a part to fully seal the box up without magnets and another model that is just a stand. Included print profiles for an A1 mini. Print a total of 6 sides, 3 with or without magnets and 3 curved sides. Next measure, cut, and make “filament pins”, these will be glued in place. Put a magnet side and a curved side together lining up the small and large holes, like the first image below.The small holes are on the sides and barely fit 1.75mm filament, glue should be lightly applied here.Push pin all the way through both parts into the glue then move the curved side to make sure it moves freely.Continue until all sides are attached, like the images below, all the holes for the magnets should come together. The 6th and f