Thingiverse
Gift Box with Lid
by abbymath
8
Downloads
2
Likes
0
Makes
This box is 140 x 160 x 80 mm and the lid is 25 mm deep. The box and lid are separate models. The striping was done with a Mosaic Palette, but could be done with manual filament swaps too since the box is a single model.
I designed it to hold 24 Escher Lizards for a gift. See my [posted make](https://cults3d.com/en/3d-printing/escher-lizards-abbymath)
---
I printed the box and lid with 0.3 mm layer height. The walls, base, and top are all 1 mm thick.
For my setup, the middle stripe starts at 27.5 mm and finishes at 55 mm.
-----
More of my models on Cults:
https://cults3d.com/en/users/abbymath
I designed it to hold 24 Escher Lizards for a gift. See my [posted make](https://cults3d.com/en/3d-printing/escher-lizards-abbymath)
---
I printed the box and lid with 0.3 mm layer height. The walls, base, and top are all 1 mm thick.
For my setup, the middle stripe starts at 27.5 mm and finishes at 55 mm.
-----
More of my models on Cults:
https://cults3d.com/en/users/abbymath
abbymath also publishes on
91 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
