Gift Card Caddy

Created out of necessity after finding multiple forgotten about gift cards, this slider box holds approximately 8 gift cards. I would think that increasing z access for a few more cards may work. I may add the blend file in the future. Initial print was PLA black and then I realized after printing the letters were in reverse.. duh. Next print I used PET Maroon but printed at the same PLA temp. I tried a higher temp print with PET and seemed to get more curl so went back to PLA temp settings. Images are printed at default PLA with low resolution. I may need to add some width to the side rails but seems to work and slide well. Since it is thinner, it would not make a good pocket carrier since the slider lid will probably come off. I designed it for putting on my sun visor, so I will probably update soon with a visor clip.