MakerWorld
Decor
Go to Model
Giger Corner Shelf
65
Downloads
85
Likes
18
Makes
This is my first corner shelf design. Normally I do flat mounted shelves (see my other models) but after many requests decided to tackle the corner. I chose to cut the very back corner off at a 45 degree angle, as not all walls are square. This should help in fitting your walls, however I can't promise they are a perfect 90 degrees. I recommend using tape on the top of your shelf, marking where the holes are and then marking the walls to install the screws. This makes it easier to install. As with all my models, download the .3mf file! Do not download the .stl as it will not have all the necessary parts to hang on your wall. If you scale it up or down, be sure to adjust the keyhole objects in the model to fit your screws. Boost MePlease consider boosting this model. Boosting helps offset the cost of labor and materials in creating these models to upload to makerworld.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
![Moon Lamp for LED Lamp 001 [HiRes] [noSupports]](https://wsrv.nl/?url=https%3A%2F%2Fmakerworld.bblmw.com%2Fmakerworld%2Fmodel%2FUSa08af97997d49e%2Fdesign%2F2024-10-27_3d0bd66d97f638.jpg&w=400&h=300)
