Thingiverse
Gilbert Engineering Rosa Wreath Mount
by jefft0825
21
Downloads
10
Likes
0
Makes
This is a mount for the Gilbert Engineering Rosa Wreath that uses 1/2 pvc and thumb screws
The middle mount has 2 pieces, one that goes on the front and one on the back with a 1/4 inch x 3 inch screw and bolt
The thumb screws are 1/4 inch and can be found on amazon
Printed everything in PETG at 30% infill - 2 outside perimeter walls
Flip the middle back piece upside down so that you have a perfect center as the front part is inset
The middle mount has 2 pieces, one that goes on the front and one on the back with a 1/4 inch x 3 inch screw and bolt
The thumb screws are 1/4 inch and can be found on amazon
Printed everything in PETG at 30% infill - 2 outside perimeter walls
Flip the middle back piece upside down so that you have a perfect center as the front part is inset
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!