Thingiverse
Gilera Logo Keyring
von timheijden21
17
Downloads
13
Likes
0
Makes
Just a keyring with the Gilera logo on it.
Width: 35.50mm
Height: 58.75mm
Thickness: about 4mm
Keyhole diameter = 3.0mm
You could ofcourse make the keychain smaller by adjusting the scale in your 3d software.
The print I did was in a rush, so it didn't turn out great. If you printed this thing, please don't hesitate to post a make!
Width: 35.50mm
Height: 58.75mm
Thickness: about 4mm
Keyhole diameter = 3.0mm
You could ofcourse make the keychain smaller by adjusting the scale in your 3d software.
The print I did was in a rush, so it didn't turn out great. If you printed this thing, please don't hesitate to post a make!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
