Gillo Weight Plate

11/5/2021
added screw holes! if the screw head doesn't fit, heat it up a bit~!
printed with PETG this time.

2/5/2021
after few shots, the screw got lose due to vibration. so I added one of those thick waterproof tape to reduce the vibration and noise; working well so far.

I also printed 3 layers of the same stuff as a cover to conceal the mess. attached to the main body with double sided tape.

25/4/2021
I had official Gillo AAA weight kit with aluminum Blade in the middle; so the setup was ABA.

I thought it was too heavy but I liked the Blade. So designed and printed 2 PLA side plates. so my setup is now PBP.

Drilled with small bit first to get the body of the screw through the hole. Drilled with bigger bit half way for the head of the screw to fit in. Used little bit of heat from a torch to push through the hole and smooth out the hole.

Haven't went out to shoot yet so I dont know how well it will take the vibrations but its sturdy so far.