Thingiverse
Gimbal for a SteadiCam
by rhmorrison
230
Downloads
256
Likes
2
Makes
This is a Gimbal designed for a DIY SteadiCam that I made for a colleague at work (See http://www.yb2normal.com/DIYsteadicam.html).
It makes use of two 624 bearings in addition to the required 608 bearing.
It would also be possible to use four 624 bearings or to use no 624 bearings. I thought using two was a good compromise. If you decide to use no 624 bearings then the height of the middle ring can be reduced to 16mm (same as the outer ring) or even 12mm.
It makes use of two 624 bearings in addition to the required 608 bearing.
It would also be possible to use four 624 bearings or to use no 624 bearings. I thought using two was a good compromise. If you decide to use no 624 bearings then the height of the middle ring can be reduced to 16mm (same as the outer ring) or even 12mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
![Printable pulley [Bearing guide] - 624 and 608](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fsite%2Fimg%2Fdefault%2FGears_display_large.webp&w=400&h=300)
