Thingiverse
Gingerbread Corner
von MVM2
26
Downloads
16
Likes
0
Makes
Printed these for the posts holding up the roof over the entry. Gives a nice look. They will fit on a 200 mm x 200 mm bed as they are. I printed them in PLA, then spray painted them white to give them an even finish,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!