Thingiverse
Gingerbread Mickey
by DayDayP
11
Downloads
8
Likes
0
Makes
My wife loves Disney. She loves gingerbread characters. But there was not a combination of the two, so I designed one for her.
This is a conglomeration of a few different prints I found. I printed at 50% and it was about an inch and a half tall. At that size on my Ender 3, it took less than 30 minutes to print.
Enjoy!
This is a conglomeration of a few different prints I found. I printed at 50% and it was about an inch and a half tall. At that size on my Ender 3, it took less than 30 minutes to print.
Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
