Glass Bed Corner brackets for Flashforge Creator Pro

These corner pieces are a perfect fit for the FlashForge Creator Pro using the glass build plate by 3DUniverse (http://shop3duniverse.com/products/glass-build-plate). There are two different brackets. Make sure the raised tab is on the short side of the build plate. I purchased some stainless 3mm wingnuts and fender washers to secure the bracket to the build plate. The oversized washer helps prevent the nut from melting into the ABS plastic when it gets hot, which causes the bracket to loosen over time. The wingnuts allow you to tighten the bracket on the fly if they do loosen. .
I'm using this shim to adjust the z-axis: http://www.thingiverse.com/thing:440022

Update: I have been printing on this glass bed for about a month now. I was using kapton tape and abs slurry previously, which worked well but I got tired of air bubbles and replacing the tape. For the glass bed I have found that glue stick works really well. I am using the Elmers purple "disappearing" extra wide g