Thingiverse
Glass lantern corners
door PiratDuck
18
Downloads
16
Likes
0
Makes
Made some simple corners that attatches to some Ikea glass frames.
The top corners give some spacing for the warm air to escape easily without heating up the plastic.
Print with supports if your printers supports remove easily.
Otherwise print on its corner so everything is at a 45 degree angle.
Recommended items needed:
6x 1.75mm glass sheets
(i had older version of these https://www.ikea.com/se/sv/catalog/products/10373768/)
Tip if you want updates or modifications
The top corners give some spacing for the warm air to escape easily without heating up the plastic.
Print with supports if your printers supports remove easily.
Otherwise print on its corner so everything is at a 45 degree angle.
Recommended items needed:
6x 1.75mm glass sheets
(i had older version of these https://www.ikea.com/se/sv/catalog/products/10373768/)
Tip if you want updates or modifications
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
