Glass Lid Holder

A larger sized stand, to hold the Bambu glass lids when you need to remove it. Stands the glass vertical and doesn't take up much space. Im in tight quarters and finding a place to lay the glass down flat is a pain, so I came up with this. The sides are tall enough so that the glass cant tip one way or the other and it keeps it from tipping over. There is a thin TPU gasket that goes at the bottom between the two uprights, to protect the bottom edge of the glass. You can use this for the smaller printers as well, just scale both the stand and TPU gasket down the same amount. I did add a pause at layer 80 and put some lead shot on the far left and right sides to make sure it was not tippy. Don't pay attention to the layer shift in the printed pictures, I ran out of filament overnight and didnt catch it for 4 hours, that's why it is there. I just dont want to print another one, haha.