Glock Holster (no hardware needed)

this is a remix of an already existing holster! Glock Holster This Holster is ment for the Glock platform. It can be used with a red dot. It is fully 3d printed and therefore no hardware needed.It can be used with belts up to 5cm.Some frames may sit a bit loose, so I recommend to use a rubber pad or simmilar to reduce noise. I redesigned the original holster and added a belt hole and removed some holes. The most drastic change though, is the clip that replaced the screw, so it can be built with no hardware. I hope you like my change have fun on the field!Boost MeIts free! :D