Thingiverse
Glock Man cave table lamp
von johnyquick
119
Downloads
86
Likes
0
Makes
A remux fromthing: 3867556 from thingiverse. Added floor plate in 2 parts and hollowed out the barrel to feed the cord. I first made a variant where the cord ran through the magazine. But that went wrong with the supports
Sliced with cura, supports: yes wall line count o. Otherwise the supports are almost impossible to remove.
the angle of the camera could have been better, but due to the size of the print there were few other options. And the print was already on its way when I realized this.
A hollow M10 tube, length about 60 mm, screws neatly into the barrel.
Sliced with cura, supports: yes wall line count o. Otherwise the supports are almost impossible to remove.
the angle of the camera could have been better, but due to the size of the print there were few other options. And the print was already on its way when I realized this.
A hollow M10 tube, length about 60 mm, screws neatly into the barrel.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
