Glowforge Air hose quick connect

This is just a simple screw on quick connect for the glowforge to an air hose. I made this guy because I was tired of pulling the thin aluminum hose off and on so many times and it breaking.

The laser_connorkter part will slide right onto the glowforge and I used a screw on air hose connector to secure it in place. the quick_connorkt is what you put onto your dryer hose, and it slips right into it. I used the spring clamp that came with the glowforge to hold that piece in place. The plug_guy part is there to plug up the dryer vent when not in use, but if you're not worried about having that vent open to the inside of your house, then you don't need it.

I did the laser_connorkter and quick_connorkt parts out of PETG at .3mm layer height, 3 walls, and 20% infill. The plug was PLA .3mm layer height, and 2 walls, given that this one doesn't need to be secured nearly as tightly as the other connectors.