Glowing Potion Bottle Stopper

# Summary:

### This is a potion bottle stopper designed to fit some "potion" bottles available on Amazon and elsewhere

### This image was taken in low lighting with some water and a small amount of milk. You will still get good results in daylight, just not quite so much glow.

# Printing tips:

### Print with the 3 LED holes on the stopper on your print bed, and the flat part of the cap on your print bed. No supports, no raft!


# Other supplies you will need:

You will also need the following things to complete the project:
- "Potion bottles":
https://www.amazon.com/Forum-Novelties-Adults-Costume-Accessory/dp/B01LFGOAKS/ref=sr_1_3?dchild=1&keywords=potion+bottle&qid=1629664223&sr=8-3
- 17.5mm ID, 1mm thick O-rings. Available at https://www.mcmaster.com/1174N106/
- CR2032 batteries. You can find these yourself.
- 3mm diameter LEDs. The color isn't important, but the diameter is! The bottle stopper holds up to 3, depending on how bright you want it to be.

- (O