Thingiverse
Glue Spreader
by MrBubbley
5
Downloads
4
Likes
0
Makes
Wife needed something to spread sewing glue on seams. Two styles. The larger one has a removeable TPU tip that inserts into the shaft. You may have to add a dab of glue if the tip pulls out while useing it.
Print the tip on it's side and the tube with the square hole down with a brim of 5. No supports. I used a brim of 3 on the tip which you have to trim off with a knife or cutters.
TPU - retraction .1mm, 205 degrees, bed 53, speed 35. This is my first TPU print so if you may have better settings. Mine printed fine with a standard extruder. I'm very impressed with TPU.
Print the tip on it's side and the tube with the square hole down with a brim of 5. No supports. I used a brim of 3 on the tip which you have to trim off with a knife or cutters.
TPU - retraction .1mm, 205 degrees, bed 53, speed 35. This is my first TPU print so if you may have better settings. Mine printed fine with a standard extruder. I'm very impressed with TPU.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
