Thingiverse
gMax 1.5 XT BLTouch Bracket
door smplman
2
Downloads
0
Likes
0
Makes
This is a BLTouch bracket for the gMax 1.5 XT. It should also work with the regular 1.5. This will not work with the XT+ printers as they have a different head design.
To install mount the bltouch to the bracket using springs to adjust the height. Then remove the two nuts and bolts holding the light bar on. Use the same holes on the head gantry to mount both the bltouch and light bar bracket.
To install mount the bltouch to the bracket using springs to adjust the height. Then remove the two nuts and bolts holding the light bar on. Use the same holes on the head gantry to mount both the bltouch and light bar bracket.
smplman publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
