Thingiverse
Gnome Vase Mode Ready
door NorbertCierpicki
1.2k
Downloads
831
Likes
10
Makes
Model was edited in Blender. Now can be printed in vase mode with no problems with gaps.
Picture shows 150mm tall gnome. Printed on modded Ender 3, 0.6 nozzle, 0.65 line width, 0.15 layer height. Printed in 2 hrs, Spectrum PLA Rust Copper.
If you see any gaps, try to lower your speeds or try to make line width bigger, even if You have only 0.4 nozzle, You can print 0.6 or 0.8 line width ;)
EDIT:
I added second model, it is more detailed and smoother than my previous remix. Also missing layers problem are fixed now.
If you see any gaps, try to lower your speeds or try to make line width bigger, even if You have only 0.4 nozzle, You can print 0.6 or 0.8 line width ;)
Picture shows 150mm tall gnome. Printed on modded Ender 3, 0.6 nozzle, 0.65 line width, 0.15 layer height. Printed in 2 hrs, Spectrum PLA Rust Copper.
If you see any gaps, try to lower your speeds or try to make line width bigger, even if You have only 0.4 nozzle, You can print 0.6 or 0.8 line width ;)
EDIT:
I added second model, it is more detailed and smoother than my previous remix. Also missing layers problem are fixed now.
If you see any gaps, try to lower your speeds or try to make line width bigger, even if You have only 0.4 nozzle, You can print 0.6 or 0.8 line width ;)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
