Go board 13x13

A 13x13 3D printable, medium size Go (Baduk, Weiqi) set designed for portability. This board is intended for intermediate learners who find a 9x9 board too limiting.

Keep in mind you need to print the board 4 times I make a full 13x13 board.

This board is compatible with standard sized 22mm go pieces.
No pieces are included in this model.

Everything in this post is fully designed to be printed by non-ams printers.
The .3mf file was for my BambuLab A1

A thinner layer height is recommended because if the positioning of the magnets is slightly off then the board feels a bit uneven if they are not aligned properly. My first prototype was with thicker draft layers but they caused me issues with vertical magnet alignment.

### Attaching magnets
Make sure to use 6mm x 3 mm sized circle magnets to be able to slot in the holes. They are designed to not have this size magnet protrude from the holes. Make sure that the pattern of the magnets are like in the image attached otherwise you will h