Thingiverse
Go-Kart Chain Guard
4
Downloads
9
Likes
0
Makes
This is a basic, generic chain guard for a go-kart.
I put a Briggs and Stratton Etek electric motor on a go-kart. The drive sprocket is about 3" diameter, so I made the guard about 5" in diameter on the rounded end. Fits for easy printing on a typical 8"x8" printer.
Guard keeps kids fingers out from between the chain and drive sprocket.
I put a Briggs and Stratton Etek electric motor on a go-kart. The drive sprocket is about 3" diameter, so I made the guard about 5" in diameter on the rounded end. Fits for easy printing on a typical 8"x8" printer.
Guard keeps kids fingers out from between the chain and drive sprocket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!